LG appliance repair in a Kingston kitchen

LG specialists, Kingston and area

LG appliance repair by Cataraqui

LG puts a linear compressor in the fridge, a direct drive motor in the washer and a sensor on almost everything else, so the codes tell you a lot once you know how to read them. Our technicians repair LG in Kingston homes, carry the parts that go first, and back the work for 90 days on parts and labour.

  • $0 service call with repair
  • 90-day warranty
  • Open 7am to 11pm
  • LG parts on the van
LG appliance repair in Kingston, Ontario

Common issues

LG faults Cataraqui technicians see every week

Pick the appliance to see the faults, what each one usually means on a LG, and what is worth trying before you book.

Fridge and freezer both slowly warming

LG built a lot of French door models around the linear compressor. When it loses capacity the whole cabinet drifts up together, unlike a defrost fault where only one side suffers. The fan keeps running, so the fridge sounds completely normal.

Try first: Put a thermometer in a glass of water on the middle shelf overnight. If both compartments read high and the back of the unit is barely warm, the sealed system needs testing rather than another reset.

Er FF or Er dH on the display

Er FF means the evaporator fan is not reporting back, usually because it is jammed in ice. Er dH says the defrost cycle ran too long. They often show up together on the same appliance.

Try first: Unplug for five minutes and see which code returns first. If it comes back within a day, leave the doors open and let it defrost fully before we come out, it speeds the visit up.

Ice maker in the door has stopped

LG door-mounted ice makers fail at the fill tube, the inlet valve or the ice maker motor. The tube ices over first, then the tray freezes into one lump and the auger stalls.

Try first: Pull the bin and check for one solid block. Clear it, press the test button and listen for the fill within a couple of minutes. Silence points at the valve or the harness.

Water dispenser slow or dribbling

Nine times out of ten this is a filter that is well past its date, and hard Kingston water gets a filter there faster. If the filter is new, the inlet valve or a kinked line behind the fridge is next.

Try first: Fit a fresh filter and run four litres through to purge the air. Still slow after that and the valve is the part to look at.

Recent repair, Polson Park, Kingston

LG fridge repair

A client with an LG French door found milk going off in three days while the freezer still made ice. They had already cleaned the coils and pulled the fridge out from the wall, and nothing changed.

Diagnosis and fix

Evaporator fan motor replaced

The fan had seized behind a layer of frost and the fridge side was getting no air at all. We replaced the motor, cleared the ice and checked the defrost heater so the same thing does not happen next winter. Covered by the 90-day warranty.

OE error, water stays in the drum

OE is the LG drain fault. The pump filter behind the little door at the bottom is the first suspect, and it fills with lint, hair and the occasional coin faster than people expect.

Try first: Lay a towel down, open the small hatch and unscrew the filter slowly, there will be more water than you think. Clear it and run a rinse. If OE returns, the drain pump is finished.

UE or dE, cycle stalls before spinning

UE is an unbalanced load, dE means the door lock did not confirm. LG direct drive machines are strict about both, so a duvet on its own or a worn door latch will stop the cycle dead.

Try first: Redistribute the load and check the door closes with a solid click. If dE returns on an empty machine, the latch assembly needs replacing.

LE error or the drum barely turns

LE points at the direct drive motor circuit, most often the rotor position sensor or a loose rotor bolt. Left running, it can take the control board with it.

Try first: Stop using the washer once LE appears more than once. Restarting repeatedly puts the board at risk, and a sensor is a far cheaper part.

Front loader smells musty

Water sits in the door boot fold and in the detergent drawer between washes. Cold cycles and too much soap speed it up, and the smell transfers to clean laundry.

Try first: Wipe the boot dry after the last load, leave the door open, and run a hot tub clean with two cups of white vinegar once a month. If the smell survives that, something is holding water in the sump.

Recent repair, Kingscourt, Kingston

LG washer repair

An LG front loader kept flashing OE and finishing cycles with water in the drum. The owner had cleaned the pump filter twice, which helped for a load or two before the error came back.

Diagnosis and fix

Drain pump replaced

The filter was clear, but the pump impeller was worn and no longer moving water at any real pressure. We replaced the pump, cleared the hose and ran a full cycle to confirm the drain. Covered by the 90-day warranty.

D80, D90 or D95 on the display

This is LG's flow sense readout, and it means the exhaust duct is restricted by that percentage. It is a warning, not a fault code, and people ignore it until the dryer stops heating.

Try first: Disconnect the duct at the back and run the dryer for a minute. Good airflow at the machine with a D90 on the panel means the blockage is in the wall duct or the vent hood outside.

Tumbles but never gets hot

On LG electric dryers the heater relay on the control board fails as often as the element itself. A thermal fuse can also open after a spell of restricted airflow.

Try first: Check that both halves of the double breaker are on, since one tripped leg gives you a turning drum and no heat. If the breaker is fine, the part needs testing.

tE1 or tE2 code

These are thermistor faults, the sensors that tell the control how hot the air is. They drift with age and the dryer either runs cold or shuts down early to protect itself.

Try first: Unplug for ten minutes and start a fresh cycle. If the same code returns, note whether it appears at the start or partway through, it helps narrow which sensor is at fault.

Rumble or squeal that grows louder

LG dryers run the drum on rollers with a tensioned belt. Flat spots on a roller give a rhythmic thump, a glazed belt gives a squeal that rises with the drum.

Try first: Run it empty for thirty seconds. Noise with nothing inside is mechanical, and replacing rollers early keeps the drum shaft from wearing.

Recent repair, Greenwood Park, Kingston

LG dryer repair

An LG dryer showed D90 for weeks and then stopped heating altogether. The lint trap was cleaned after every load, so the owner assumed the duct was fine and the heater had simply failed.

Diagnosis and fix

Thermal fuse replaced and duct cleared

The wall duct was packed almost solid at the elbow, which had cooked the thermal fuse. We cleared the run, replaced the fuse and tested the temperature rise across a full cycle. Covered by the 90-day warranty.

OE error, water left in the tub

The LG drain fault. Between the filter, the drain hose loop under the sink and the pump, one of the three is holding water back. New garbage disposals are a regular culprit when the knockout plug is left in.

Try first: Lift out the filter and rinse it, then check that the drain hose rises in a high loop under the counter. If a disposal went in recently, confirm the plug was removed.

AE error, leak detected

LG dishwashers carry a float in the base pan. Even a slow drip from a hose clamp trips it, and the machine will not run again until the pan is dry.

Try first: Tip the unit forward gently to empty the pan and dry it out. If AE clears and comes back, there is a live leak that needs finding rather than mopping.

Dishes come out gritty

TrueSteam and QuadWash models push water through a lot of small nozzles, and Kingston water leaves scale in them. Pressure drops and the top rack suffers first.

Try first: Unclip the arms and clear every nozzle with a toothpick, then run a hot empty cycle with dishwasher cleaner. No change means the circulation pump is weak.

Buttons unresponsive or the cycle will not start

Door latch switches fail more often than control boards on LG dishwashers. The door looks shut, but the machine never gets the signal that it is safe to fill.

Try first: Press the door firmly while starting a cycle. If it fires up with pressure on the door, the latch switch is the part, not the board.

Recent repair, Barriefield

LG dishwasher repair

An LG QuadWash was stopping mid-cycle with AE on the display. The client had dried the floor under the unit twice and could not see where the water was coming from.

Diagnosis and fix

Leaking sump gasket replaced

The base pan float had tripped on a slow weep from the sump gasket, too little to reach the floor but enough for the sensor. Gasket replaced, pan dried and two full cycles run as a test. Covered by the 90-day warranty.

Burner clicks and will not catch

LG sealed burners need a clean electrode and a cap seated flat. Spills bake onto the electrode tip and the spark jumps to the wrong place.

Try first: Lift the cap, brush the electrode with a dry toothbrush and seat the cap square. If every burner clicks at once, the spark module is failing rather than one igniter.

Induction zone stops mid-cook

LG induction tops shut a zone down when the electronics underneath overheat, usually because the vent path below the cooktop is blocked by a drawer or stored trays.

Try first: Clear anything stored directly under the cooktop and try again. If it still cuts out on a normal pan, the cooling fan or that zone's board needs looking at.

F9 or F11 on an electric range

F9 means the oven is not reaching temperature in the expected time, F11 points at a stuck key on the panel. Both are common on models past the five-year mark.

Try first: Cut the breaker for five minutes. If F11 clears and comes back, the membrane panel is on its way out and the board behind it is at risk.

Glass top element stays cold

Either the radiant element has opened up or the infinite switch behind the knob has failed. On LG the switch fails slightly more often, especially on the large front zone.

Try first: Test the same pan on another zone to confirm the fault is isolated. One dead zone with the rest fine is an element or a switch, not the board.

Recent repair, Rideau Heights, Kingston

LG range repair

A client had an LG induction range where the right front zone shut off partway through cooking, with no code and no pattern they could see.

Diagnosis and fix

Cooling fan replaced

The fan under the cooktop had seized, so the zone was hitting its thermal limit and protecting itself. We replaced the fan, cleared the dust from the vent path and ran all four zones at full power for twenty minutes. Covered by the 90-day warranty.

Oven never gets to temperature

The hidden bake element under the floor of LG ovens is the usual failure. You cannot see it glow, so people blame the thermostat and spend money in the wrong place.

Try first: Set 350 and check whether the broil element at the top glows while nothing happens below. That split is the signature of a failed hidden bake element.

Food cooks unevenly

The oven sensor drifts with age and LG ovens can end up 20 to 50 degrees off the display. Convection models add a second variable if the fan has stopped.

Try first: Leave an oven thermometer on the middle rack at 350 for twenty minutes. More than 25 degrees out and the sensor is the part to change.

Door locked after EasyClean or self-clean

The latch motor gets the most abuse during a clean cycle. If the cavity is cool and the door still will not release, the motor or its switch has failed.

Try first: Let it cool completely, then cut the breaker for a minute to reset the control. Never lever the door, the catch breaks and the repair triples.

Heat escaping around the door

LG door gaskets flatten out and hinges lose tension, so the door sits a few millimetres proud. Cooking times stretch and the kitchen gets warm.

Try first: Run your hand around the closed door at temperature. Any draught means the gasket, and a door that does not sit flush usually means hinges.

Recent repair, Westbrook, Kingston

LG oven repair

Roasts were taking half an hour longer than they used to in an LG wall oven, with no code on the display and the fan running normally.

Diagnosis and fix

Hidden bake element replaced

The element under the oven floor had failed, leaving only the broil element to do the work. Replaced, and a test bake held 350 within a few degrees. Covered by the 90-day warranty.

How it works

Four steps from your call to a working LG

Talk to a technician
01

Schedule

Call or send the form. You get an arrival window on that first conversation, not a vague half-day promise.

02

Diagnose

The technician tests the LG on site and reads the codes properly before quoting a single part.

03

Repair

The parts that fail most on LG ride with us, so most Kingston jobs finish on the first visit.

04

Guaranteed

Ninety days on parts and labour, written on the invoice. Same fault inside that window and we come back at no charge.

Booking a LG repair

Call us directly or leave a request, we call back within the hour

Give us the model number from the door frame and any code on the display. On LG that usually names the part before we leave the shop, which is why so many of these jobs finish in one visit.

Working hours Mon to Sun, 7am to 11pm
Phone (613) 706-2378

LG repairs across

Downtown KingstonSydenham WardWilliamsvillePortsmouthKingscourtRideau HeightsPolson ParkReddendaleBayridgeWestbrookCataraqui NorthGreenwood ParkBarriefieldAmherstviewOdessaGlenburnie

Book your LG repair

Leave your number and a Cataraqui technician calls you back within the hour during opening hours.